The HuntingPA.com Outdoor Community banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6,828 Posts
Dimensions aren't critical as long as the entrance is guarded.
I use #0's.
I use 1" x 6" pine or oak.
Sides are cut 12" long.
Front & back is 6" wide.
Hole diameter is 1 1/2".
No floor.
Use anything for roof.

If'n I do use a #1 LS, I will lean the loose jaw against the side wall.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top