The HuntingPA.com Outdoor Community banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 1 of 1 Posts

· Registered
Joined
·
1,704 Posts
I just got done fixing and tuning up my friends, to make it work the best here are my suggestions. Get the frizzen carberized, they have a thin layer from factory and wear quickly, use english flints, and get a uncle mike's or equivalent hot touchhole. Triple seven pellets seem to work better in it but any moisture(fog etc..) gives these guns a fit on ignition, also the two screws that hold the lock are 2 different length, male sure when u put them back together u put the correct one in or else u will lose 1 like my friend did. I like more traditional muzzy's but to get into it and have fun without breaking the bank go ahead good buy
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top