The HuntingPA.com Outdoor Community banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 4 of 4 Posts

· Registered
Joined
·
76 Posts
Discussion Starter · #1 ·
I own a T/C White Mountain Carbine .50 cal flintlock and have been wandering lately whether it is possible/feasible to swap a double-trigger assembly from a Renegade or Hawken rifle for the factory trigger? As far I can tell the stock and lock are the same on all models.

Has anyone done this or know if it would work? What's the cost involved?
 

· Registered
Joined
·
8,409 Posts
The mortise for the DST is different. Don't know that there would be room for DST's in the trigger guard. You may need to switch trigger guards as well. It would require carving out larger mortises. It may be substantially easier to install a single set trigger.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top