[BuckFever101]

I have some slick tricks that even after tightening you can move the blades a slighty, is this normal or did I receive some defective broadheads?

 

[fishkrane]

I have some like that too,must be normal I guess

 

[BuckKilla]

I don't think thats normal guys. I have 100gr and 125gr and neither are lose after i tighten them.

 

[BuckFever101]

yeah its almost as if the channel where the blades fit are to wide or maybe its they sent the reg blades with the magnum blade center piece?

 

[SpiritNugent]

I don't think thats normal guys. I have 100gr and 125gr and neither are lose after i tighten them.

I agree... I think they should try new/different o-rings.

 

[Venatic]

My 85gr. blades do not move at all. I always crank them down tight with a broadhead wrench to seat the insert and O-ring against the back of the blades. If they are loose after that then something is not right.

V

 

[fishkrane]

I just tried switching o rings around,now they are good and tight,it wasn't a problem with many,just a couple.

 

[mauser06]

good to hear ya got it fixed...i'll have to remember that if i ever have that problem with my grizz tricks..

i was impressed with the blade system as it was pretty ingenious...almost difficult to get them out once they are in even when not screwed on an arrow...

 

[SpiritNugent]

I just tried switching o rings around,now they are good and tight,it wasn't a problem with many,just a couple.

 

[Guest]

Oh man I love my Slick Tricks!