The HuntingPA.com Outdoor Community banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 6 of 6 Posts

·
Registered
Joined
·
593 Posts
Discussion Starter · #1 ·
Has any one ever docked the barrell of a shotgun? I want to take the choke off of a modified barrel. I've been told that either cutting it off with a hacksaw or useing a pipe cutter and deburring it works. I will be keeping the barrell about 19 inches. thoughts?
 

·
Registered
Joined
·
678 Posts
Be carefull you may change the point of the patterns impact. I did this years ago with a model 37 that had a full choke and a 30" barel. I wanted to use it for grouse and rabbits in the thick stuff so cylinder was what I was looking for. Cut it down to 26" and it patterned 3 feet low. Just something to think about.

Pappy
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top