The HuntingPA.com Outdoor Community banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,877 Posts
Discussion Starter #1
Ok i am not a complete novice on this matter but i am having a hard time locating a mount for my Model 66 6shot revolver
i have found 1 set but spending $80 is a little steap

any help or direction to follow would be very helpful
Thanx
Rick
 

·
Registered
Joined
·
1,615 Posts
take the rears off the top and see if thers 4 screw holes.. you can try looken at the bottom of the top strap not sure if the screw holes would go all the way though ... if ther are 4 screw holes or even three at that matter.. it the same as the weaver base for j,k,l frames

dose it look some thing like this, if so it shares the same mount as the smiths.. and if it dose just look at weavers web site for ther base number an call up like gander and some other shooting stores thats sell them then just take the gun in a box with triger lock on and ask to make sure it lines up right ..
good luck

http://www.gunbroker.com/Auction/ViewItem.asp?Item=140940718
 
1 - 2 of 2 Posts
Top