The HuntingPA.com Outdoor Community banner
1 - 8 of 8 Posts

·
Registered
Joined
·
12,729 Posts
It's threaded into the barrel.

Is there a threaded hole or did the sight break off leaving the base in the barrel?
 

·
Registered
Joined
·
787 Posts
Discussion Starter · #5 ·
I just checked the barrel, and yes there is a hole where the bead should be, but, the problem is that I had a choke system put in a few years back, and I don't think that there is enough metal left in the barrel. Is there a way to anchor the bead other than screwing it in ? i.e. glue or solder ?
 

·
Registered
Joined
·
12,729 Posts
Can you see any threads?

There were some fiber optic sights that used double faced tape. You may be able to try one of those.
 

·
Registered
Joined
·
12,729 Posts
They usually are thin and there may only be a couple of threads but that is enough. If you do I check and get the thread size. There are some differences.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top