The HuntingPA.com Outdoor Community banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6,563 Posts
Discussion Starter #1
Hello,

I picked up an older Remington police shotgun and I bought ghost ring sights for it and a rail for a red dot. How do I remove the front ramp bead sight? I think it is silver soldered on.

I'm going to get the whole gun cerrakoted when I am finished with it so I was thinking about heating it up? How difficult of a project is this, or should I take it to a gunsmith?
 

·
Registered
Joined
·
24,796 Posts
** This one I would let a smith do. Have them remove it when they do the new coating. Shouldn't be that much more - and they have everything to do it right including experience.
 

·
Registered
Joined
·
3,770 Posts
Agreed. You need a much higher heat to remove those, you can do a lot of damage if your not tuned into such things.
 
1 - 3 of 3 Posts
Top