The HuntingPA.com Outdoor Community banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 20 of 46 Posts

· Registered
Joined
·
3,516 Posts
Discussion Starter · #1 ·
Well I finally broke down and ordered a new aluminum trigger guard for my Remington 600.It wasn't broke but didn't want to wait till it was and not be able to get one or have prices jump.Got it from Coquille Vally Machine Works.Its Perfect!Looks identical to the origional only its blued aluminum.Dropped right in,used same screws,perfect fit!I'll keep the old one around just to have the origional.
 

· Registered
Joined
·
31 Posts
410-er said:
Well I finally broke down and ordered a new aluminum trigger guard for my Remington 600.It wasn't broke but didn't want to wait till it was and not be able to get one or have prices jump.Got it from Coquille Vally Machine Works.Its Perfect!Looks identical to the origional only its blued aluminum.Dropped right in,used same screws,perfect fit!I'll keep the old one around just to have the origional.
Thanks for the good words Tom, I'm glad you like it.

Willie
 

· Registered
Joined
·
31 Posts
Not the best pic, but here ya go.........



This is also in 308.

Here's another, from the bottom.

 

· Registered
Joined
·
31 Posts
I have had no complaints about fit, regardless of Caliber.
I've sold well over 200 Trigger guards.
 
1 - 20 of 46 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top