The HuntingPA.com Outdoor Community banner

1 - 2 of 2 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
Long story, but I was given 5 of these arrows. The quiver on my Parker Buckbuster won't hold their small diameter shafts. Is there a different rubber insert that I can get or do I need a new quiver to use these? They shoot accurate and penetrate way more than my X-bolts so I would like to try them this season.
 

·
Registered
Joined
·
362 Posts
Just add something to build up the arrow holding section on the quiver.... I had the same problem once and went to a craft store and got some felt with one sided tape on it... put it in the slots and arrows were held in there just fine....If you are happy with the arrows you may find a different quiver, but most are made for regular sized shafts so you have a hard time.... Good luck
 
1 - 2 of 2 Posts
Top