The HuntingPA.com Outdoor Community banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 5 of 5 Posts

· Registered
Joined
·
355 Posts
Here is one I built made it out of 15" coragated plastic pipe 5'1/2 feet wide.Put a 1 1/2" shaft through it made a frame and it works great.

 

· Registered
Joined
·
355 Posts
Should mention I poured it full of concrete welded rods on center shaft to hold it in the center of pipe.Also had some concrete wire that I put it it.The bearings are just 3" round stock milled out a little bigger than the 1 1/2" shaft with grease fittings tapped in it.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top