The HuntingPA.com Outdoor Community banner

1 - 1 of 1 Posts

·
Registered
Joined
·
12,139 Posts
Discussion Starter #1
Bought a Lyman Brass Master and plan to use Lee dies in the shell holder (9 mm and .45 ACP). The press is on back order, BTW.
So anywho, I am getting all the "infrastructure" ready and my plan is to use my RCBS Powder measure with the Lee Expander die; BUT - the male thread on the powder measure does not fit with the female thread on top of the Lee Expander die (curses, foiled again!).
Is there an adapter I need to get the RCBS powder measure married up with the Lee Expander die or just how does this work? In the past I used an RCBS Rockchucker press and powder metering was done by a separate operation and a loading block.
Never used a progressive press before so this is uncharted waters for me.

:nerd:
 
1 - 1 of 1 Posts
Top