The HuntingPA.com Outdoor Community banner
1 - 1 of 1 Posts

·
Registered
Joined
·
857 Posts
fishkrane said:
Underneath the stand,behind the rubber there are two hollow pieces that run the length of the stand,I took two pieced of flat stock that fit snugly into the channels,and grinded a small point on each one,drilled a hole through them,through the channels,and bolted them fast,leaving them stick out about an inch.they really bite into the tree,they will not slip.if you want pictures,pm me your email adress,I can send some tomorrow.
I bought a stand that had this done. Seemed to work alright.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top