The HuntingPA.com Outdoor Community banner

1 - 5 of 5 Posts

·
Registered
Joined
·
287 Posts
Discussion Starter #1
Ok so I have a Savage Edge (now the Axis) and the trigger is pretty bad i was wondering if there was any way to lighten the trigger pull and if i need to take it to a gunsmith and an estimated cost
 

·
Registered
Joined
·
1,350 Posts
you can "snip" a coil off of the tension spring (one small spring inside the other). start small (1/4 to 1/3 a coil) and cut more as needed. it should be a double spring. snip the larger one. i think the lowest that trigger can go is somehwere around 3lbs. you should be right at about 5.5lbs right now correct? make sure you check the sear so that it isnt slipping
 

·
Registered
Joined
·
3,815 Posts
I think it best to take it to a competent gunsmith. The charge is about $25-40. well worth it, and he will make it what ever your want. My gun gives you about 2.5 pounds, after you feel it if you want it lighter, he does that free..
 

·
Registered
Joined
·
287 Posts
Discussion Starter #5
thanks guys any of you know a good smith willing to drive
 
1 - 5 of 5 Posts
Top