The HuntingPA.com Outdoor Community banner

1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I would like to know what length of fletching
is being used by everyone for your crossbows?
I read somewhere that anything under 22" will not
stabilize with fletching under 5"
I use 150gr muzzy crosskill fixed broadhead.
 

·
Registered
Joined
·
12,252 Posts
I use 2" blazers with a helical fletch on them and have found them to stabilize very well. I use the Arizona EZ Fletch bolt to fletch them.
 

·
Registered
Joined
·
3,101 Posts
I use 2" predators and blazers....but I'm only shooting 125 grain tips....I have no problems shooting up to 50 yards when on the range..
 

·
Registered
Joined
·
222 Posts
cspot said:
I use 2" blazers with a helical fletch on them and have found them to stabilize very well. I use the Arizona EZ Fletch bolt to fletch them.
Yep....Same Here.
 

·
Registered
Joined
·
18,621 Posts
I am currently using two inch Blazers. Have shot 3 inch Norways as well in addition to typical factory 4 and 5 inch stuff.

As long as you front of center is towards the 17% and over range, short vanes work extremely well.
 

·
Registered
Joined
·
3,908 Posts
I like 2 inch Blazers fletched in the Arizona and 2 inch Fusions fletched in the Jo-Jan with 3 degree right offset. Some bows with a narrow barrel groove will need the 3 inch Fusions or the 2.88 inch Vane-Tec vanes. I prefer the Vane-Tec.
 
1 - 6 of 6 Posts
Top