The HuntingPA.com Outdoor Community banner

1 - 6 of 6 Posts

·
Registered
Joined
·
646 Posts
Discussion Starter #1
I know the Remington 788 came in a carbine that was a 18.5 inch barrel and a 22 inch barrel.

I have an old family 788 in .308 win and it should probably be retired. It still drives tacks, but the sling post on front is pulling out if the stock and its just generally seen better days.

I love the gun however and want to find the same one. So I measured my 788 and the barrel seems to be about 20.5 inches from where I think I should measure?

Can anyone post a pic on where to measure from on the receiver? The factory site is still on mine so I doubt it was ever cut.

I'm hoping to trade some guns or bulk ammo for another but I want the same barrel length preferably.

Thanks!
 

·
Registered
Joined
·
3,600 Posts
kyle31490 said:
So I measured my 788 and the barrel seems to be about 20.5 inches from where I think I should measure? measure?

Can anyone post a pic on where to measure from on the receiver? The factory site is still on mine so I doubt it was ever cut.

Thanks!
Barrel length is measured from the closed locked breach face to the muzzle or any permanently attached device, brake, flash hider, etc.

The simple way, close and lock the bolt, insert a wooden dowel or cleaning rod in the muzzle then push in until it stops. Mark the dowel or rod, pull it out then measure the length to the mark.

Bill
 

·
Registered
Joined
·
3,600 Posts
kyle31490 said:
I know the Remington 788 came in a carbine that was a 18.5 inch barrel and a 22 inch barrel.

I have an old family 788 in .308 win and it should probably be retired. It still drives tacks, but the sling post on front is pulling out if the stock and its just generally seen better days.

Thanks!
Why retire the old one?

The sling sling swivel stud is a easy fix. If its the course wood screw type a couple toothpicks and some waterproof wood glue it will make it like new. If its a machine thread (10-32) then inlet a hex nut. I forget which they use....its been a while since I worked on one.

If it drives tacks you're not going to find one any better, only one that's worse. Price wise, some think they're made of gold and owned by a past president. They're not and its a 99.99% chance it wasn't.

The stock? It can be brought back to life, read the sticky on stock refinishing.

If you absolutely 100% have to have a longer barrel get it rebarreled. Until you spend the bucks for a used relic you'll have a better piece of pipe at roughly the same cost. Its pretty much a no brainer.

Bill
 

·
Registered
Joined
·
646 Posts
Discussion Starter #6
I likely will fix the sling post at some point.

The real reason I don't want to tamper with it is because its a bit of an heirloom. My grandfather bought it new, handed it down to my father, whom handed it down to me. I'm torn if fixing it up takes somethin away from it. I'd like to give it to my son in about 15 years so I don't know. The many scratches in the stock have lots of stories behind them, many of which I only could wish I know.

I guess I'm afraid to continue using it. It holds a lot of sentimental value.

I should keep it usable though...
 
1 - 6 of 6 Posts
Top