The HuntingPA.com Outdoor Community banner

1 - 7 of 7 Posts

·
Registered
Joined
·
524 Posts
Discussion Starter #1
Looking to have a Remington 1100 barrel cut and tapped for chokes, any idea of the cost and a good shop to have it done at I am located in Lawrence County (1A) area
 

·
Registered
Joined
·
195 Posts
It sounds like your mind's made up and you've done your homework, but check your references, though, because everything I've heard is to stay away from that on an 1100 barrel - the walls are too thin to do it well, so I've been told.
 

·
Registered
Joined
·
5,834 Posts
Call or email Briley, and see what they have to say about it......
 

·
Registered
Joined
·
300 Posts
Go on Remingtons website and find the phone number for the custom shop and ask them. If it can be done, they can do it
 

·
Registered
Joined
·
117 Posts
bpashunt said:
It sounds like your mind's made up and you've done your homework, but check your references, though, because everything I've heard is to stay away from that on an 1100 barrel - the walls are too thin to do it well, so I've been told.
I wish some one would have told me that...I been doing them for 22 years. $125.00 with 3 chokes
 
1 - 7 of 7 Posts
Top