The HuntingPA.com Outdoor Community banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 4 of 4 Posts

· Registered
Joined
·
1,671 Posts
LONEWOLF5347 said:
I find to drill 2 new holes for the rear peep about 1/2" from the front tang screw other wise you have to dig into the stock for good eye placement
Yes you do have to drill and tap two new mounting holes , i used tape to hold the sight on and kept sholdering the gun until the sight felt right for me and than marked and drilled and tapped it.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top