The HuntingPA.com Outdoor Community banner

1 - 2 of 2 Posts

·
Registered
Joined
·
781 Posts
Discussion Starter #1
I lost my powder spout so I cut the head off of a 222 casing and drilled a 3/8" hole in a spare lid (finding a spare lid could be a challenge). My lid was an old metal one so I soldered the casing into the lid. I think if I was making another one I would just use epoxy. It took about fifteen minutes and the powder flows really nice. Sure makes loading the powder measure easier.
 

·
Registered
Joined
·
1,881 Posts
Yup, any small case in the metal lid does great, for the new plastic goex cans I epoxied a honey nozzle, from that little honey bear, into to cap, works great!
 
1 - 2 of 2 Posts
Top