Drill/tap??

904 Views 6 Replies 5 Participants Last post by beagler, Jan 5, 2013

MQ-1

Discussion Starter · Jan 3, 2013

I have an 870 Rem 20 g that I'd like to get drilled/tapped. What do you think it would cost and where in NE PA would you recommend getting it done? Thanks for any insight.

Save

1 - 1 of 7 Posts

Should run you about 10 bucks a hole plus parts. I had mine done to fit the smaller reflex and micro dot sites and my smith drilled three holes and cut down the original weaver base for Remmys and it works beautifully.