The HuntingPA.com Outdoor Community banner

1 - 7 of 7 Posts

·
Registered
Joined
·
7,680 Posts
Discussion Starter #1
I have an 870 Rem 20 g that I'd like to get drilled/tapped. What do you think it would cost and where in NE PA would you recommend getting it done? Thanks for any insight.
 

·
Registered
Joined
·
3,391 Posts
Should run you about 10 bucks a hole plus parts. I had mine done to fit the smaller reflex and micro dot sites and my smith drilled three holes and cut down the original weaver base for Remmys and it works beautifully.
 

·
Registered
Joined
·
2,973 Posts
Dave's Gun Shop in Drums D&T'd mine right there in the shop when it arrived. Cost @ $20. They did a fantastic job.
 

·
Registered
Joined
·
18,426 Posts
A guy I know said he opened a shop next to North American Warhorse in Dunmore if I needed any custom work done.
 

·
Registered
Joined
·
7,680 Posts
Discussion Starter #6
Chet, get me his info. I won an 870 Rem 20 and I'm pimpin it out for turkey next spring.
 
1 - 7 of 7 Posts
Top