The HuntingPA.com Outdoor Community banner

1 - 7 of 7 Posts

·
Registered
Joined
·
303 Posts
Discussion Starter #1
I've been using a wood canoe rack I made many years ago that slips into the bed of my P/U truck. It has about rotted away and I'm thinking about building one out of PVC pipe and fittings for the same purpose. Does anybody have any pictures of designs they've come up with, especially one that extends over the cab?
 

·
Registered
Joined
·
303 Posts
Discussion Starter #3
Thanks for your input, buckinnuts. I'm looking strictly for a rack to carry a canoe, though. That design isn't quite what I'm looking for but it sure does point out how many PVC fittings would be required. Perhaps my idea isn't as cost efficient as I first thought.
 

·
Registered
Joined
·
2,044 Posts
I would just make another set out of wood and store it out of the elements when not in use. My Dad made a set 30 years ago and they're still holding up.
 

·
Registered
Joined
·
1,299 Posts
I have a nice Yakima canoe carrier I’d like to sell to someone if interested.
I can email pics.?
 

·
Registered
Joined
·
3,494 Posts
I have had racks for my pickups since 1988. A simple screen over the rear window, and rails down the sides to tie stuff to. The one on the 07 250 was one I rebuilt from a full sized bed off a 95 F150 that was my fathers. I also had a rack that was off my 97 short bed. Well the 2020 250 has a 6'9" short bed that is longer than the 97 short bed. The cab is also higher from the bed than either the 07 250 (had to make it higher to fit the 07) or the short bed 97. So a lot of measure, remeasure, rethink existing racks, 1 trip to the metal shop, some welding rods, 3 cut off wheels, a grinding wheel, paint, 4 kayak racks, some 3/8the rebar, and we have a winner.
158743

I needed to make the rails longer so since I am not a good welder, I cut 2 10" pieces off the 8' rack, closed the ends, and welded them to the bottom of the shortbed rack instead of trying to buttsplice. I welded 2 pocket feet to the front of 2x1 square tube, then drilled and tapped then for 5/16 so I could bolt it to the bed, then put shorter pocket feet on the rear.
Then I took parts of the 8' rails and made a frame that is the same size as the frame the screen is on. Welded a angle to both sides, gusseted with 3/8 rebar. Drilled a 3/8 hole in it so I can remove it for normal use. Since I had the torch and rebar out, I made 2 tie downs that I welded to the front frame on the top outside.
84.80 got me 4 kayak J bars from amazon. The only thing I had to do was slice a hole in the screen on the left and right side front to slide the bottom of the J bar through.
158744


Took them to the state park this morning. The orange one is 15' and about 57(lb), the yellow is 18' and 68lb. They stayed there at highway speed and through all the turns on the back roads.
The rear part came off and 2 tightners for the front J bars came off quick and all of it is stored with the kayaks. I think I have a winner. A regular rack/screen and a kayak rack.
You need to be about 5' 10" or better to get the boat up there, but it isnt hard. Put the nose in the front J bar with the back on the ground, lift and slide forward, then lift into the rear J bar.
158741
158742
 
1 - 7 of 7 Posts
Top