The HuntingPA.com Outdoor Community banner

1 - 11 of 11 Posts

·
Registered
Joined
·
881 Posts
Discussion Starter #1
Where in the archives can i find this? I'm sure you guys must have discussed it before. I would like to do this to my 870, but don't now how.
 

·
Registered
Joined
·
3,274 Posts
theres a good tutorial on the oldgobbler forum.
 

·
Super Moderator
Joined
·
12,799 Posts
When I did it I used a muzzleloader ram rod...it fit my cordless drill...a 20ga brush (for a 12ga) oil and green and blue scotch bright pads...

Oil the brush and a piece of green scotch bright..make it so the pad is what's touching the bore...wrap the brush in it and cut to size...oil the pad dripping...run it through the bore while running the drill..not crazy fast but run the drill...

Do a couple pads of green...might need to run a dry patch now and again...I did it outside...it is a bit messy but you need the oil to lubricate..

After the green do a few blue patches...


Patch dry....

Should be a mirror...

Some use steel wool etc but that's a mess...
 

·
Registered
Joined
·
1,197 Posts
when I used the old gobbler method, I stuck a choke tube in the barrell so that I could polsh right to the end of the barrell w/o mucking up the threads. Luckily I had a couple of chokes that I did not use.
 
1 - 11 of 11 Posts
Top