The HuntingPA.com Outdoor Community banner

1 - 2 of 2 Posts

·
Registered
Joined
·
853 Posts
Discussion Starter #1
I have antlers mounted on a board that fell off of the wall and the tip of the main beam broke off. This piece fits nicely back into place where it belongs but I am curious how to go about fixing this. What would be the best glue to use and what procedure should I take to fix this?
 

·
Registered
Joined
·
2,870 Posts
5 minute epoxy will work for you! If it is a bigger section sometimes need to put a piece of wire in it also will help hold it better. From the sounds of it though you should just need the epoxy.
 
1 - 2 of 2 Posts
Top