The HuntingPA.com Outdoor Community banner

1 - 5 of 5 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I am going to change over my plastic nocks to aluminum and then mill them out to make moon nocks out of them. By gluing them in first I can be assured that the nock doesn't twist as it dries. That happened to the last arrows I bought and now the nocks are all funky. Anyone know where I can get flat aluminum nocks to fit Easton XX75 2216's? I could make them myself I suppose but for a buck a piece it's not worth turning on my lathe.
 

·
Registered
Joined
·
89 Posts
A lot of people are doing this now. I'm using some plastic and some aluminum. A round file does the trick and t hey you can polish them up. Ask Arrowhead.
 

·
Registered
Joined
·
12 Posts
Discussion Starter #4
Looks like I'm going to be making my own. Oh well, that's one of the fringe benefits of having my own machine shop!
 

·
Registered
Joined
·
4,161 Posts
i use BH inserts for my flat nocks in my 2117 arrows for my exocet
....i just chuck the arrow in my drill and bout 10 seconds with some 400 grit paper and all is good........bob

....
 
1 - 5 of 5 Posts
Top