The HuntingPA.com Outdoor Community banner

Sako AV action...

5K views 14 replies 9 participants last post by  hootshoot 
#1 ·
i was cleaning my Sako AV after another successful season, and removed the bolt completely to clean it. this bolt has some moving parts, and I can't seem to get itback in properly. I can get it back in past the bolt release,and about 3/4ths closed. there is a slot in the reciever where the firing pin mechanism slides into, but the pin isn't lining up with the groove in the stock by the safety. any Suggestions before I have to take it to the gun shop?? Thanks!
 
#13 ·
PUT a flat piece of metal across the back bump hanging down off the firing pin, I use the edge of a 90 degree shaft of a screwdriver..at the same time your pulling back, rotate it in the right direction to go over that little bump and then release it past that bump..now you know how hard the firing pin hits the primer...no big deal!
 
You have insufficient privileges to reply here.
Top